ELFCULB 10AWG Solar to XT60i Charging Cable Solar Panel Extention Cable for Portable Power Station River 600 Solar Generator Battery Pack(25FT)

I ordered several of these and would have given them a 5 star except one of cables had a bad positive wire contact and wouldn't work. The others worked great.

Well Made, Quality Cable! Proper Negative Grounded “i” Conductor for Ecoflow! Soft, supple insulation.A lot of these XT60i cables have the triggering conductor not connected to either + or -.Have to then pry and dig into the connector to bridge the center pin as needed and then the connector looks ugly and possibly damaged.Not this one! If you need the center pin bridged to negative as in the case of my Delta2 Max, this one is GTG right out of the package.

Haven’t tried it out yet but it looks ok

Good quality cable for short run from panel to charging unit.

Seems to be built well, no issues, works as intended

Just to confirm, this has the middle pin on the XT-60i cable connected to GROUND/Negative lead, which allows EcoFlow Generators to use the higher 15A solar charging as compared to the car chargers (or just a normal XT-60 which floats the pin) which are limited to 8A.

Confirmed with EcoFlow Delta 3 plusCenter pin to ground confirmedWell build wire gauge is actually what it’s advertised as and construction is solid

I have several EcoFlow power stations, and the MC4 to XT60i cables are not included. EcoFlow charges a lot of money for a very short cable. For a few dollars more, this cable has a better insulation and heavier gauge wire at 25 ft long. Now that is great value.The heavier gauge 10 AWG wire is more efficient and carries voltage and amperage better than the typical 12 AWG cable associated with the standard (and very expensive) MC4 to XT60i cables EcoFlow sells.The cables are great. No more connecting extension cables with multiple connections. Get these and you have a direct connection from the panels to the power station. 5 stars from me.

Excelent!

The 10 gauge cable and ends are good quality. They worked very well for my two solar panels at 400watts.

Good quality, xt60i neg ground as needed for ecoflow solar

m4 connector broke

Very good

Build quality is excellent. This 25' cable is heavy validating the presence of 12 awg copper wire. The center signal pin of the XT60i plug end is properly connected to the negative lead. This allows the inverter to know you are using solar panel input instead of 12VDC automobile input which will thus provide full charging power to be utilized.